Description
ConFlex™ UltraCrete™ Textured Masonry Topcoat is a coating used to produce a textured finish on properly prepared interior or exterior surfaces. The pleasing texture results has the ability to minimize defects and irregularities found on poured cement aggregate block.
Material Use
Variants: CF17W0801 Fine Extra White, CF17W0811 Medium Extra White, CF17W0821 Extra Coarse Extra White
ConFlex UltraCrete is a 100% acrylic, aggregate-filled texture coating intended for both interior and exterior use. It is designed to provide a decorative textured finish that helps conceal surface defects and irregularities on substrates like cement, concrete, and drywall. It is suitable for side walls and ceilings, offering a low eg-shel finish and mildew resistance.
System Components
ConFlex UltraCrete is used in conjunction with various primers depending on the substrate:
- Concrete, Masonry, Stucco, CMU: May be applied directly on pH 6–9 surfaces. For higher pH, use Loxon Concrete & Masonry Primer or Loxon Acrylic Block Surfacer.
- Steel: Prime with All Surface Enamel Primer.
- Exterior Wood & Composition Board: Prime with Exterior Oil-Based Wood Primer.
- Interior Drywall: Prime with ProMar 200 Zero VOC Latex Primer.
- Exterior Drywall: Prime with Exterior Latex Wood Primer.
Applications
Suitable surfaces include:
- Concrete
- CMU blocks
- Stucco
- Tilt-up and precast concrete
- Drywall (interior and exterior)
- Primed steel
- Primed wood
- Cement composition siding panels
Not for use on horizontal surfaces (floors, decks), undersides of balconies, below grade, or submerged applications.
Application Details
- Application Tools:
- Small areas: Brush or roller
- Fine/Medium Textures: Graco TexSpray RTX 5000 pi (30–35 psi, 3/16–1/4" tip)
- Extra Coarse Texture: Graco 10:1 President Texture Pump (for aggregate coatings)
- Reduction: Do not reduce.
- Coverage: 50–80 sq. ft. per gallon, varies with texture and surface.
- Dry Time @ 77°F / 50% RH:
- To touch: 30 minutes – 1 hour
- To recoat: 2 hours
- Temperature Requirements: Minimum 40°F for air, surface, and material. Must remain above 40°F for 48 hours post-application. Avoid use when surface is near dew point.
- Cleanup: Soap and warm water; flush spray equipment with compatible solvent.
Special Notes
- Volume Solids: 41 ±2%
- Weight Solids: 54 ±2%
- VOC: < 50 g/L (0.42 lbs/gal), compliant with OTC, CARB, LEED VOC
- Pot Life: Not specified (ready-to-use product)
- Cure Times: Not explicitly defined beyond dry-to-touch and recoat periods
- UV Stability: Not directly mentioned; not recommended for floor or roof use implies limited UV durability
- Wet Film Thickness (WFT): Not provided in mils; however, DFT for water resistance was tested at 13.5–18 mils
- Adhesion & Durability Tests: Passed ASTM standards for flexibility, adhesion (concrete), impact resistance, salt spray (steel), and alkali resistance.
- Shelf Life: 36 months (unopened)
- Limitations: Avoid use where hydrostatic pressure is a concern. Texture may abrade in high-wear areas. Not resistant to standing water.
https://www.sherwin-williams.com/painting-contractors/products/conflex-ultracrete-acrylic-texture-coating
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.